AIR TEMP SENSOR (IAT1-8)

IN STOCK - AVAILABLE FOR ORDER

060121011230

AED200

  • 15-11-2019(if ordered today before 12 PM) / 16-11-2019(if ordered after 12 PM)

All the products shipped from dubai

Why to Shop at Subzeromotorsport.com

  • 24/7 Sales Support

    Need Help? Call our 24/7 support, 600 544 045.

  • 100% Genuine Products

    We deliver genuine products through out the Middle East.

  • Lowest Price Guaranteed

    We assure,you receive the best price when you look directly with us.

PRODUCT DESCRIPTION

Air temperature greatly effects an engines optimal ignition timing as well as the required fuel injection duration on an engine being controlled based on speed density calculations (i.e. no mass air flow meter). Most aftermarket engine management systems operate based on speed density principals and for these systems, accurate air temperature measurement is very important.  In these cases the Inlet Air Temperature (IAT) sensor should be mounted just before the throttle to best measure the temperature of the air actually being ingested by the engine.  This creates some challenges for forced-induction (turbocharged and supercharged) engines as this temperature rises and falls very quickly. In order to track the fast changing air temperatures, a fast-response Inlet Air Temperature sensor is required.

 

To meet these requirements, we offer a fast-response Inlet Air Temperature sensor which is suitable for both naturally-aspirated and forced-induction engines.

 

FEATURES

 

  • 1/8″ NPT thread – Either drill and tap your own hole or use the supplied alloy weld-on boss
  • Deutsch DTM 2-way connector – High quality sealed connection with plug housing and terminals included
  • Uses the same resistance vs. temperature calibration curve as most Delphi IAT sensors that were fitted to General Motors engines – Can be used with any ECU that can accept this calibration (Link, Vipec, Motec, Haltech, HKS F-Con, etc)

 

Note: Not recommended for applications where the IAT may reach 120 degrees or more. In practice all this only applies to forced induction engines being run without an intercooler.

Reviews

No customer reviews for the moment.

Write a review

AIR TEMP SENSOR (IAT1-8)

AIR TEMP SENSOR (IAT1-8)

LINK AIR TEMP SENSOR (IAT1-8)

LINK AIR TEMP SENSOR (IAT1-8) offer the fastest-response Inlet Air Temperature sensor which is suitable for both naturally-aspirated and forced-induction engines.1/8″ NPT thread – Either drill and tap your own hole or use the supplied alloy weld-on.mounting bosses available

 

30 other products in the same category: